FAQ
1. A distance is displayed and/or a sound signal is triggered when there is no obstacle behind the vehicle:
- Check that the sensors have not been installed too low (height) and that they are not pointing to the ground (angle).
- Check that the sensor is not installed upside-down.
- Unplug one sensor at a time to identify the cause of the anomaly.
2. A low obstacle behind the vehicle is not detected by the beep&park® system.
- Check that the sensors have not been installed too high (height) and that they are not pointing to the sky (angle).
- Check that the sensor is not installed upside-down.
3. The display does not power on after installation.
- Check that the screen's power supply is connected properly.
- Check that the engine has been started and that the vehicle is in reverse.
- Check that all cables are properly connected.
4. The display indicates a defective sensor.
- Check that the sensor surface is clean.
- Check that the sensor wires are properly plugged into the ECU.
- Check that the sensor wires are not damaged.
5. The display message states that the reverse gear has not been selected.
- Check whether the ECU power cable is connected to the reverse light wire.
6. The object's position does not correspond to the correct indicator on the display.
- Check that the sensor wires are plugged into the ECU in the correct order (using the markers ABCDEFGH).
